Our main product is the manufacture of rubber belts, among which the triangular belts is one of our products. The following are the precautions for the later use of the V-belt.
Daily maintenance
Operators and users should master the correct operation essentials during normal driving. According to the technical requirements of the instruction manual, try to avoid sudden start and sudden braking; also prevent frequent overloading; the machine should be removed from long-term use.
Inspection Method
Apply a vertical pressure of about 2 kilograms to the middle of each tape by hand, and the appropriate sink amount is 20 to 30 mm. If it is not suitable, adjust it in time.
Do not mix the new and the old: When double or more triangle tapes need to be replaced, the specified type of triangle tape should be selected, and the tightness of each group of triangle tapes should be the same. It is not allowed to mix the new and the old or reduce the number of use. Uneven force, even the old V-belt does not work, affecting power transmission and shortening the life of the V-belt.
Cause of fracture
1. After the belt core is used for a long time, the structure is destroyed
2. The belt has poor stretch resistance;
3. The belt's anti-extrusion ability is poor;
4. The wrapping quality of the belt is not good enough;
5. The lengths of the two belts are inconsistent and interfere with each other during operation
In addition, the hexagonal belts is also one of our products, welcome your inquiry and contact.\
A Brief Introduction To High-performance V-belts
Main Failure Modes Of High-performance V-belt
How To Maintain High-performance V-belt
Several Major Elements Of High-performance V-belt Maintenance
Design Of High-performance V-belt
Our main product is the manufacture of rubber belts. The common, High Performance V-Belt is one of our products.
The main failure modes of high-performance V-belt are as follows:
(1) The belt slips on the pulley and cannot transmit power.
(2) Delamination, tearing and breaking of the belt due to fatigue.
(3) Wear of the working surface of the belt.
(4) Torsional vibration of the driven shaft.
Ensuring that the belt does not slip during work, has a certain fatigue strength and service life is the main basis for the design of the V-belt, and it is also the main basis for the design of other belt transmissions that rely on friction transmission.
maintain
1. When the tension of the triangle tape is checked regularly, the specified requirements cannot be met after adjustment, and a new triangle tape must be replaced. All belts on the same pulley should be replaced at the same time. Otherwise, the load on the V-belt will be unevenly distributed due to the difference between the new and the old and the different lengths. This will cause the V-belt to vibrate, drive unevenly, and reduce the work of the V-belt drive. effectiveness.
2. During use, the operating temperature of the V-belt should not exceed 60℃, and do not apply belt grease casually. If you find that the surface of the V-belt is shiny, it means that the V-belt has slipped. First, remove the dirt on the surface of the belt, and then apply an appropriate amount of belt wax. When cleaning the V-belt, use warm water instead of cold or hot water.
3. For various types of V-belts, it is not advisable to apply rosin or viscous substances, and prevent contamination of engine oil, butter, diesel and gasoline, otherwise it will corrode the V-belts and shorten the service life. The groove of the V-belt must not be stained with oil, otherwise it will slip.
4. Keep the V-belt when it is not in use. It should be stored in a place where the temperature is relatively low, there is no direct sunlight, no oil and corrosive smoke, to prevent its deterioration.
Usually, High strength V-Belt is also one of our best-selling products, welcome your inquiry and contact.